Help Desk -
9958816305, 9810335381
Email
Password

Venus Metals announces metallurgical test results in Western Australia

Mining News - Published on Thu, 18 Oct 2018

Image Source: ABN Newswire
The Directors of Venus Metals Corporation Limited announced the results of preliminary beneficiation testwork on an oxide composite sample from the Youanmi Vanadium Project, Western Australia.

HIGHLIGHTS:
- The grade increased from 0.58% V2O5 to 0.80% V2O5 with a recovery close to 80% of the Vanadium.
- At -1 mm more than 40% of the mass can be rejected whilst recovering 80% of the Vanadium.
- Mass rejection of gangue minerals decreases downstream processing volume and is expected to reduce acid consumption.
- Assay by size data suggests the oxide sample can be significantly beneficiated without the need to grind the sample.
- Crush sizes tested showed minimal variation in the beneficiation potential.
- Further testwork is planned for hydrometallurgical studies on a beneficiated sample.

Metallurgical Testwork
The Company commissioned METS Engineering Group ("METS") to develop a series of metallurgical tests aimed at beneficiating an oxide composite formed using different intervals from the deposit (see Table-1 in link below) (see Figure 1 in link below). The oxide composite was formed from shallow intervals spanning five diamond core holes seen in the table below (see link below). Only half of the mass for each interval was utilised, with the remaining kept in reserve. A total composite mass of approximately 48 kg was formed. The representative composite encompassed various weathered zones and a range of different spatial locations throughout the deposit.

Beneficiation testwork focused on low cost methods that avoided grinding. The testwork was conducted at three crush sizes: -3.35 mm, -2 mm and -1 mm (refer Appendix-1 JORC Table) (see link below). Due to the friable nature of the oxide ore these crush sizes are expected to be achievable using a combination of comminution technologies.

Detailed size by assay tests illustrated that a significant portion of the mass reports to the fine size fractions and contains very little vanadium. Simple rejection of fines resulted in an increase in Vanadium grade from 0.58% V2O5 to a maximum grade of 0.83% V2O5. The beneficiation process was not overly sensitive to crush size, suggesting fine crush sizes may not be required. The grade-recovery profiles for each crush size can be seen in Figure 2 (see link below).

A key outcome from this testwork was the high Vanadium recovery achieved. The grade-recovery profile illustrates that the material can be beneficiated to 0.80% V2O5 whilst recovering close to 80% of the Vanadium.

This compares to conventional magnetic separation, which typically struggles to achieve high vanadium recoveries on oxidised material.

Mills can contribute a significant amount of capital and operating expense, with much of the power utilised in milling consumed by the grinding of gangue minerals. This alternative beneficiation process avoids milling and the associated costs.

Source :

Posted By : Rabi Wangkhem on Thu, 18 Oct 2018
Related News from Mining segment